Hardware manual

34
Charge
method
Constant voltage method
- By integrated
battery charge
circuit
Battery
charge
time
Approx. 5 hours
- By integrated
battery charge
circuit
Dimensions Approx. 120 (W) x 144 (D) x 129 (H)
mm
Weight Approx. 300 g
• Pin layout
The pin layout below shows when the cradle is viewed at its front.
Figure 2.2
• Pin layout and the description
Table 2.6
Pin no. Signal Description Direction
1 V CRADLE Power supply to the terminal and charge to
battery pack installed in the terminal.
-
2 D + USB D + IN / OUT
3 D - USB D - IN / OUT
4 USB_ID Switch-over between USB host and USB client OUT (Note 1)
5 V BUS Power from/to USB cradle IN / OUT (Note 2)
6 GND GND -
Notes:
1. The output is made from the cradle.
2. The direction “OUT” is for USB mode, or “IN” for LAN mode.