Specifications

151
State transition diagram
Note1: To perform cloning again in response to some setting change on the owner terminal once
backup data is transferred to a client terminal using this software, be sure to perform full
backup on the owner terminal, rather than partial backup.
Note2: After the owner terminal has became the P2P access point , that owner terminal can not
detect the late added client terminal whose Wi-Fi Direct enabled. In above case, the P2P
access point mode on the owner terminal should be disabled to detect such client terminal.
Initializing…
Searching client devices…
Connecting(1/N)
Connecting(2/N)
Waiting…
データ送信中…
データ送信中…
Connecting (N/N)
Sending data…
：
Terminal bocomes Wi-Fi P2P access point.
Checking terminal that starting Copy Devices application.
(See Note 2.)
Connection process performs
sequentially. Wait about 30seconds per
one terminal.
At the time to connect with eight
terminals, stop connecting with other
terminals.
“N” is number of terminals on current
loop.
Retrieve the data from client terminal by
HTTP protocol. (Parallel processing)
If elapsed for about 1 minute after initialization, cancel P2P access
point and re-initialize.
No
Terminals
detected.
Zipping…
Archive all data under /mnt/sdcard