Specifications

36
Validation
Validation is carried out for a specified number of times in the range of 1 to 9 (Default = 3) to
check if scanned data is valid, and then the data is output only if it is valid. The number of
validations can be set either at the control panel or using the Common Device Control Library.
No. of Scanning Times
In “Continuous Scanning” mode, scanning continues for the preset number of scanning times in
the range of 1 to 9 (Default = 1) and then it will stop in waiting mode. The number of times for
scanning can be set either at the control panel or using the Common Device Control Library.
Scanning Period
Valid time period of scanning in the range of 1 to 9 (Default = 3) seconds after the trigger key was
pressed down can be set either at the control panel or using the Common Device Control Library.
After the preset time has elapsed, the scanner will go into standby mode waiting for the trigger
key to be pressed down again.
Double Scanning Prevention
This is used to prevent double scanning of the same bar code during the “Continuous Scanning”
mode is being set. Scanning the same bar code again will be prohibited as long as the scanning
continues for the preset number of times. However, it can be scanned when a new “Continuous
Scanning” starts.