Owner's Manual

Using BEST SHOT

13.

Use [8] and [2] to select the second control panel option from the

bottom (Trigger Sense).

14.

Use [4] and [6] to select the subject movement sensitivity, and then

press [SET].

• You can select any one of three sensitivity levels: “High”, “Normal”, or “Low”.

• Move Out CS Setting Guide

• Move In CS Setting Guide

. To shoot using Move Out CS

1. Compose the image so the subject is within the boundary on the

monitor screen.

2. Half-press the shutter button.

• The camera will adjust exposure and focus automatically.

3. When the boundary on the monitor screen turns

green, press the shutter button the rest of the

way down.

At this time the camera will go into recording standby

and start pre-recording images and storing them in a

buffer, in accordance with the Prerecord CS shots

setting you configured in step 11 under “To setup the

camera” on page 75. After the buffer becomes full, new images keep being added

while older images are continually being deleted.

The camera will start saving images automatically the moment it detects that the

subject has moved out of the boundary.

•“0 AUTO” flashes on the monitor screen during recording standby and auto

recording.

High: For a subject that moves out of the boundary quickly

Low : For a subject that moves out of the boundary slowly

High: For a subject that moves into the boundary quickly or for a small subject

(relative to the boundary)

Low : For a subject that moves into the boundary slowly or for a large subject

(relative to the boundary)