User Manual
Table Of Contents
- Accessories
- Read this first!
- Using This Camera for the First Time
- Using This Camera with Another (Separately Available) Camera
- Contents
- General Guide
- Quick Start Basics
- Shooting with the Camera
- Controlling the Camera with a Smartphone
- Controlling Your Camera with a Smartphone
- Getting Ready to Establish a Connection between a Smartphone and Your Camera
- Using a Smartphone as a Camera Remote Controller (Shoot with phone)
- Viewing Snapshots and Movies in Camera Memory on a Smartphone (View on phone)
- Having Images Shot with the Camera Sent to a Smartphone Automatically (Auto Send)
- Unpairing the Camera from a Smartphone (Unpair)
- Operating the Camera with the Controller of Another (Separately Available) CASIO Camera
- Printing
- Using the Camera with a Computer
- Appendix
14
Quick Start Basics
IMPORTANT!
• A battery that has not been used for a long time and/or ambient temperature can
cause charging to take longer than normal. These conditions may also cause the
operation lamp to flash red. If this happens, refer to page 70.
• The USB-AC adaptor will become warm during charging. This is normal and does
not indicate malfunction.
• The shape of the power plug depends on each country or geographic area.
If the operation lamp is not lit or flashing during charging, check the orientation of the
USB cable connector.
• Make sure that you insert the cable connector into the USB port until you feel it
click securely into place. Failure to insert the connector fully can result in poor
communication or malfunction.
• Note that even while the connector is fully inserted, you
still will be able to see the metal part of the connector
as shown in the illustration.
. To charge using a USB connection to a computer
While the camera is turned off, connect in the sequence shown below (
,
).
• If the camera is on, hold down [p] (Power) for about two seconds to turn it off
before connecting to the computer.
Charging time
:
Approximately 2 hours 55 minutes
USB
2
1
Micro USB cable
(included with camera)
[USB] port
USB port
Computer
(power turned on)
Connect the cable so the
u
mark on the small (micro USB) connector is facing the lens
side of the camera when inserted.
[USB] cover