User Manual
Table Of Contents
- Accessories
- Read this first!
- Using This Camera for the First Time
- Using This Camera with Another (Separately Available) Camera
- Contents
- General Guide
- Quick Start Basics
- Shooting with the Camera
- Controlling the Camera with a Smartphone
- Controlling Your Camera with a Smartphone
- Getting Ready to Establish a Connection between a Smartphone and Your Camera
- Using a Smartphone as a Camera Remote Controller (Shoot with phone)
- Viewing Snapshots and Movies in Camera Memory on a Smartphone (View on phone)
- Having Images Shot with the Camera Sent to a Smartphone Automatically (Auto Send)
- Unpairing the Camera from a Smartphone (Unpair)
- Operating the Camera with the Controller of Another (Separately Available) CASIO Camera
- Printing
- Using the Camera with a Computer
- Appendix
70
Appendix
. If the camera operation lamp starts flashing red...
If the camera operation lamp starts flashing red during charging, it means that further
charging is not possible for one of the reasons below. Perform the actions described
below to correct the problem and then try charging again.
Ambient temperature or the temperature of the battery is abnormally high
or low
Unplug the USB cable from the camera and wait for a while until the camera is within
the temperature range of 15°C to 35°C (59°F to 95°F), and then try charging again.
Safety timer activated
A battery that has not been used for a long time, certain types of computers, and
connection conditions can cause charging to take longer than normal. If charging
takes for about five hours, a safety timer will terminate it automatically, even if the
battery is not fully charged. If the battery has not been used for a very long time,
charging may terminate automatically after only about 60 minutes.
1) Using a battery that has not been used for a long time.
Disconnect and then reconnect the USB cable to resume charging.
2) Insufficient power supply when connected to computer
The camera can be charged only via a USB 2.0 standard USB port. Connect
directly to a USB port what supplies a current of 500mA.
For details about the power supply capacity of a computer’s USB port, contact the
manufacturer of the computer. Though disconnecting and then reconnecting the USB
cable will resume charging, you may need to do so repeatedly if the power supply
capacity of the computer is low.
Power Supply
Charging
If problems persist after you perform the above steps or if the battery fails to
charge after 5 hours, it could mean that the battery is faulty. Contact your nearest
CASIO authorized service center.