User Manual

Quick Start Basics

1. Press the camera or controller shutter button.

The camera will automatically put the entire image

in focus, and then shoot the snapshot.

• Normally, shooting a snapshot will cause the

operation lamp to flash red once.

Shooting a Movie

Press [0] (Movie) on the camera or controller to start

movie recording.

Recording will stop if you press [0] (Movie) again.

See page 48 for details.

NOTE

• You can also shoot by touching the screen (page 51).

• With this mode, the image size is fixed at 15M

(3888

3888).

• The operation lamp flashes red while movie recording

is in progress.

. Shooting with the Camera Alone

You can use the camera in a stand-alone configuration

without turning on the controller or otherwise establishing a connection between it

and the camera.

• If an Interval Shooting (page 44) operation or movie recording (page 48) is in

progress, it will continue to shoot images even when controller power is turned off.

To shoot a snapshot

Shutter button

Camera

Controller

[0] (Movie)

Shutter button

Operation lamp