User Guide
Table Of Contents
- UNPACKING
- CONTENTS
- QUICK START BASICS
- INTRODUCTION
- GETTING READY
- SHOOTING A SNAPSHOT
- SHOOTING A MOVIE
- USING BEST SHOT
- ADVANCED SETTINGS
- Changing the Focus Mode
- Correcting Image Brightness (EV Shift)
- Controlling White Balance
- Specifying ISO Sensitivity
- Specifying the Metering Mode
- Using the Camera’s Filter Effects
- Controlling Image Sharpness
- Controlling Color Saturation
- Adjusting Image Contrast
- Date Stamping Snapshots
- Using the On-screen Histogram to Check Exposure
- Other Useful Recording Functions
- VIEWING SNAPSHOTS AND MOVIES
- EDITING IMAGES
- USING AUDIO
- MANAGING YOUR FILES
- DELETING FILES
- OTHER SETTINGS
- Configuring Camera Sound Settings
- Turning the Startup Screen On or Off
- Specifying the File Name Serial Number Generation Rule
- Changing the Camera Date and Time Setting
- Using World Time
- Changing the Display Language
- Changing the USB Port Protocol
- [_] (REC) and [>] (PLAY) Button Settings
- Formatting Built-in Memory
- PRINTING
- USING THE CAMERA WITH A COMPUTER
- APPENDIX
223
APPENDIX
Other
The wrong date and time are
displayed.
The date and time setting is wrong. Set the correct date and time (page 165).
The messages on the display
are in the wrong language.
The wrong display language is selected. Change the display language setting (page 169).
I can’t transfer images over a
USB connection.
1) The USB cable may not be connected securely. Check all connections.
2) USB driver may not be installed. Install the USB driver (page 186).
3) The USB driver may have been installed incorrectly. Reinstall the USB driver correctly (page 186).
4) The wrong USB communication protocol may be selected. Select the correct USB communication
protocol in accordance with the type of device you are connecting (page 170).
5) If the camera is not turned on, turn it on.
Display language setting
screen appears when the
camera is turned on.
1) You did not configure initial settings after purchasing the camera or the battery may have been left with
a dead battery. Check the camera setup (pages 11, 165).
2) There may be a problem with the camera’s built-in memory management area. If this is the case,
perform the reset operation to initialize the camera’s setup (page 124). After that, configure each setting.
If the language selection screen does not re-appear when you turn the camera on, it means that the
camera’s built-in memory management area has been restored.
If the same message appears after you turn power back on, contact your retailer or a CASIO service
center.
Problem Possible Causes and Action