Operation Manual

135
Other Playback Functions (PLAY MENU)
This procedure combines two movies. The play times of the each movies must be
less than 10 minutes, and the two movies must be of the same quality and frame rate.
Note that merging of two High Speed Movies is not supported.
• Display one of the movies you want to merge before performing this operation.
1. Use [4] and [6] to select the movie you want to merge with the one
that was displayed when you pressed [MENU].
Only movies that can be merged with (that are the same quality and frame rate
as) the movie displayed when you pressed [MENU] will be displayed.
2. Use [8] and [2] to select “Create” and then press [SET].
This will create a new movie that is a combination of movie that was displayed
when you pressed [MENU] and the movie you selected in step 1, above.
• The original two movies are not affected.
NOTE
• In the case of FHD or HD quality movies, some movies may not be able to be
merged because of differences in frame rates due to the recording mode, or the Art
Shot or Time Lapse scene used.
• A movie shot with another camera model cannot be merged with this function.
• The original movies are not affected when merged. Make sure the memory card
you are using has sufficient unused space before using this function.
• Depending on the movies, the merge operation may take some time to complete.
• Display the movie that contains the frame you want to use to create a snapshot
before performing this operation.
1. Use [4] and [6] to scroll through the movie frames and display the one
you want to use as the image of the MOTION PRINT image.
Holding down [4] or [6] scrolls at high speed.
• You can also perform this operation using the function ring.
2. Use [8] and [2] to select “Create” and then press [SET].
• Only the frames of movies recorded on this camera can be used in a MOTION
PRINT image.
To merge two movies (Movie Merge)
Menu item: Movie Merge
Creating a Snapshot of a Movie Frame (MOTION PRINT)
Menu item: MOTION PRINT