User Manual

13
. Smartphone Operation
11. Confirm that the EXILIM Remote for GOLF app screen shows the
remote capture screen.
• About 60 seconds after the camera establishes a connection with the
smartphone, the camera’s monitor screen will go blank and its back lamp will
light green.
• If the message “Connect your phone to the access point below.” remains on
the camera display, change the smartphone’s Wi-Fi settings so the SSID of the
camera you are using is selected.
12. Tap “Driver” (select club) and then select the club you plan to use.
13. Tap “ ” (Fullmiere).
The message “Press the button on the 3D swing sensor.”
will appear on the smartphone display.
14. Put the smartphone in a location where you can
view its display.
. 3D Sensor Operation
15. After assuming the address position with the club’s shaft at 90 degrees
to the target line, press the button on the 3D swing sensor.
• Remain still in the address position as the 3D swing sensor sets the target line.
• After setting of the target line is complete, you will hear a voice say “Let’s go
ahead and swing!” and movie recording will start.
16. Swing the club.
Movie recording will stop automatically after the swing is complete.
• Complete the swing within 10 seconds after you hear a voice say “Let’s go
ahead and swing!” If the swing goes past 10 seconds, you will not be able to
edit the movie even if “On” is selected for the “Movie Editing (Golf)” setting.
. Phone Operation
17. Tap “Cancel” to exit swing data collection.
18. Tap “ ” (Send Last Shot).
The recorded movie will be sent to the smartphone, and then the Fullmiere app
will start up automatically.
• You can re-record the movie by pressing the 3D swing sensor button before
tapping “ ” (Send Last Shot).