Specifications

— 19 —
7. Slide the battery switch back to the NORMAL OPERATION position.
8. Press the power on key (BN-10: ON, BN-20: ON/OFF) to turn on power.
This causes the contrast adjustment screen to appear.
9. Use the and cursor keys to adjust the contrast of the display, and then press OK.
If nothing appears on the display after you press the power on key, remove the batteries and then
reload them into the BN Unit, making sure you follow proper procedures.
If this does not solve the problem, refer to “Troubleshooting” on page 40.
10. In response to the message that appears (CHECK YOUR HOME TIME SETTING AND COR-
RECT IT IF NECESSARY!), press OK. This enters the CLOCK Mode.
11. Check the Home Time setting and make changes if necessary as described below.
12. Perform the procedure under “To set the on-screen message language” on page 10 to specify
the language you want to use.
Entering the CLOCK Mode
Press CLOCK to enter the CLOCK Mode. When you do, an initial dual clock screen appears, which
shows the current time in your Home Time zone and a World Time zone.
“NORMAL OPERATION”
1 Home Time clock
2 World Time clock
3 City name
1
2
3