User`s guide

E-44

k Solution Display

After inputting and registering values on the coefficient editor screen,

press = to display the solution(s) for the equation.

• Each press of = displays the next solution, if there is one. Pressing

= while the final solution is displayed returns to the coefficient

editor screen.

• In the case of simultaneous linear equations, you can use f and

c to switch the display between the solutions for X and Y (and

Z).

•When there are multiple solutions for a quadratic or cubic equation,

you can use the f and c keys to scroll the display between X1,

X2, and X3. The actual number of solutions depends on the

equation.

•Pressing A while a solution is displayed will return to the coefficient

editor screen.

• The display format of solutions is in accordance with the input/

output format and complex number display format settings of the

calculator’s setup screen.

• Note that you cannot transform values to engineering notation while

an equation solution is displayed.

Appendix Equation Calculation: <#066> to <#070>

Generating a Number Table

from a Function (TABLE)

All calculations in this section are performed in the TABLE Mode

(N4).

k Configuring a Number Table Generation

Function

The procedure below configures the number table generation

function with the following settings.

Function: f(x) = x

Start Value: 1, End Value: 5, Step Value: 1

LINE

(1) Press N4(TABLE).

(2) Input the function.