User manual - fx-7400GII_Soft

20051101

3-3

Using Advanced Setup

k Channel Setup

The Channel Setup screen shows the sensors that are currently assigned to each channel

(CH1, CH2, CH3, SONIC, Mic).

To configure Channel Setup settings

1. While the Advanced Setup menu (page 3-1) is on the display, press b(Channel).

• This displays the Channel Setup screen.

Currently selected channel

Channel Setup Screen

2. Use the f and c cursor keys to move the highlighting to the channel whose setting

you want to change.

3. What you need to do next depends on the currently selected channel.

• CH1, CH2, or CH3

Press a function key to display a menu of sensors that can be assigned to the selected

channel.

1(CASIO) ...... Displays a menu of CASIO sensors.

2(VRNR) ....... Displays a menu of Vernier sensors.

3(CSTM) ....... Displays a menu of custom probes.

4(None) ......... Press this key when you want leave the channel without any sensor

assigned to it.

• SONIC Channel

Press a function key to display a menu of sensors that can be assigned to this channel.

1(CASIO) ...... Displays a menu of CASIO sensors, but only “Motion” can be

selected.

2(VRNR) ....... Displays a menu of Vernier sensors. You can select “Motion” or

“Photogate”.

Note

• On the menu that appears after you select “Motion” from either the CASIO or

Vernier sensor menu, select either “meters” or “feet” as the sampling unit.

• After selecting “Motion” from either the CASIO or Vernier sensor menu, you can

press the K key to toggle “smoothing (correction of measurement error)” on

(“-Smooth” displayed) and off (“-Smooth” not displayed).

20070101