User Manual

8-28
k Specifying a List File for Use in a Program
You can specify a list file to be used when executing a list operation in a program. Display
formats are as shown in the example below.
File <file number> ... number: 1 to 6
k Using List Sort Functions in a Program
These functions let you sort data in lists into ascending or descending order.
• Ascending order
1 2
SortA ( List 1, List 2, List 3 )
Lists to be sorted (up to six can be specified)
1
431
2
K11
• Descending order
3
SortD ( List 1, List 2, List 3 )
Lists to be sorted (up to six can be specified)
3
432
k Using Statistical Calculations and Graphs in a Program
Including statistical calculations and graphing operations in a program lets you calculate and
graph statistical data.
u To set conditions and draw a statistical graph
Following a StatGraph command (“S-Gph1”, “S-Gph2”, or “S-Gph3”), you must specify the
following graph conditions:
• Graph draw/non-draw status (DrawOn/DrawOff)
• Graph Type
•
x -axis data location (list name)
•
y -axis data location (list name)
• Frequency data location (list name)
• Mark Type
(Cross, Dot, Square)
• Pie graph display setting (% or Data)
•
Pie graph percentage data storage list specification (None or list name)
• First bar graph data (list name)
• Second and third bar graph data (list name)
• Bar graph orientation (Length or Horizontal)
The graph conditions that are required depends on the graph type. See “Changing Graph
Parameters” (
page 6-1).