User Manual

α-3
Message Meaning Countermeasure
Can’t Simplify • Fraction simplification was attempted
using the 'Simp function (page
2-23), but simplification could not be
performed using the specified divisor.
Example: Specifying a divisor of 3 to
simplify the fraction 4/8.
•
Specify a different divisor or
execute 'Simp without specifying
any divisor.
Can’t Solve!
Adjust initial
value or
bounds. Then
try again.
• A Solve calculation could not obtain
a solution within the specified range.
• Change the specified range.
• Correct the input expression.
No Variable
1 No variable specified within a graph
function being used for Dynamic
Graph.
2 No variable within a Solve equation.
1 Specify a variable for the graph
function.
2 Input a Solve equation that
includes a variable.
Conversion
ERROR
• Attempting to use the unit
conversion command to convert
between two units in different
categories.
• Executing a conversion calculation
using the same command twice in a
conversion expression.
• In a conversion expression,
specify two different commands
that are in the same category.
CSV error
in row [A] or
column [B]*
1
• The imported CSV file included data
that cannot be converted.
• Use your computer to check the
row A, column B data in the file
and change it to data that can be
converted.
USB Connect
ERROR*
1
• USB cable connection broken
during data communication.
• Use the USB cable to correctly
connect the calculator and
computer (or other device).
Com ERROR • Problem with cable connection or
parameter setting during program
data communication.
• Check to make sure there is
nothing wrong with the cable
connection, and that parameters
are configured correctly.
Transmit
ERROR
• Problem with cable connection
or parameter setting during data
communication.
•
Check to make sure there is
nothing wrong with the cable
connection, and that parameters
are configured correctly.
Receive
ERROR
• Problem with cable connection
or parameter setting during data
communication.
• Check to make sure there is
nothing wrong with the cable
connection, and that parameters
are configured correctly.
Memory Full •
Memory of receiving unit
became full during program data
communication.
• Delete some data stored in the
receiving unit and try again.