User Manual

α-4
Message Meaning Countermeasure
Invalid Data
Size
• Attempting to send data of a
size that is not supported by the
receiving device.
Example: Attempting to send a
matrix with more than 256 lines from
the fx-9750G
III to an older model.
• Make sure the data being sent is
of a size that is supported by the
receiving device.
Invalid Data
Number
• Attempting to send data with a data
number that is not supported by the
receiving device.
Example: Attempting to send
List 7 from the fx-9750G
III to an
older model that supports only up
to List 6.
• Specify a data number supported
by the receiving device when
sending data.
Time Out • A Solve calculation or integration
calculation was unable to satisfy
convergence conditions.
• If you are performing a Solve
calculation, try changing to the
initial default estimated value.
• If you are performing an
integration calculation, try
changing to a larger
tol value.
Circular
ERROR
• There is a circular reference
(such as “=A1” in cell A1) in the
spreadsheet.
• Change cell contents to remove
the circular references.
Please
Reconnect
• The connection was dropped for
some reason while updating the
operating system.
• Reconnect and try again.
Sub-folders
in this folder
cannot be
displayed*
1
• In the MEMORY mode, a level 3
nested storage memory folder is
displayed, and it contains a level
4 nested folder. (The level 4 folder
will be displayed, but it cannot be
opened.)
• Use your computer*
2
to store all
files you want to access in the top
three folder nesting levels.
Too Much Data • The number of data items is too
large.
• Delete unneeded data.
Fragmentation
ERROR
• Memory must be optimized before
any more data can be stored.
• Optimize
memory.
Invalid Name • The file name you input includes
invalid characters.
• Use the correct characters to
input a valid file name.
Invalid Type • An illegal data type is specified. • Specify valid data.
Storage
Memory Full
• The storage memory is full. • Delete unneeded data.
Data ERROR • A data error occurred. • Check to make sure you are
writing correct type of data and try
again.