User Manual

1-21
Important!
• In the e • ACT mode, the copy operation described here can be performed on a calculation
result line of a calculation line only.
• In the RUN
•
MAT mode, this operation is possible only when Setup screen settings are
configured as shown below.
- Mode: Comp
- Input/Output: fx-9860G
III: Math, fx-9750GIII: Math or Mth/Mix
In the e • ACT mode, this operation can be performed regardless of Setup screen settings.
u To copy a calculation result line in history
1. Move the cursor to the location in the bottom input line
where you want to insert the copied content.*
1
2. Press !f.*
2
3. Use f and c move the highlighting to the calculation
result line you want to copy.*
3
4. Press w.*
4
*
1
When the bottom input line in the e • ACT mode is a text line, you cannot copy to the text
line cursor position. In this case, completing step 3 of the above procedure will insert a new
calculation line at the bottom, to which the content will be copied.
*
2
Be sure to perform the !f key operation in step 2 (which exits input line editing) when
copying to the destinations described below.
• To the gray locations of the functions below
- Improper fraction: - Mixed fraction:
- Integral:
- Σ Calculation:
• To the second or subsequent line of a matrix or vector
In cases other than the above, you can skip the key operation in step 2.

∫
=
( )