User Manual

β-2
5. Press J.
• Only the settings below are saved before entering the Examination Mode.
Input/Output, Frac Result, Angle, Complex Mode, Display, Q1Q3 Type, Language, Function
menu language, Battery Type
u Calculator Operation in the Examination Mode
• Entering the Examination Mode causes the entire display screen to be surrounded by a
green boundary. A flashing display icon (
) will also appear on the display. The flash rate of
the icon slows down about 15 minutes after entering the Examination Mode.
Icon
Green boundary
• In the Examination Mode, the Auto Power Off trigger setting is fixed at approximately 60
minutes.
• Pressing a- causes the dialog box shown below to appear. The dialog box shows the
elapsed time in the Examination Mode.
You can restart the elapsed time count by performing one of the operations below.
- Press the RESTART button.
- Remove the calculator’s batteries.
- Delete Main Memory data.
- Re-enter the Examination Mode while already in the Examination Mode.
• The table below shows how certain operations affect the Examination Mode.
If you do this:
The calculator stays in
Examination Mode.
Data input in Examination
Mode is retained.
Turn power off and then back on
again
Yes Yes
Press the RESTART button Yes No
Remove the calculator’s batteries Yes No
Delete Main Memory data Yes No