User Manual

Playing with Different Tones
EN-19
English
8. To cancel layering and switch to a single tone
(Upper 1), press the LAYER button or EXIT
button.
• Each press of the LAYER button toggles between
unlayered (one tone) and layered (two tones).
• Entering the Duet Mode (page EN-17) or Duet Pan
Mode will disable layering.
• Configuring of layering settings is not supported by
MIDI Recorder Track 2 recording.
1. Hold down the LAYER button until the screen
shown below appears.
2. Use the q and w arrow buttons to select
“Layer Balance”.
3. Use the u (–) and i (+) arrow buttons to
adjust the layer volume balance.
• –1 or lower: Increases the Upper 1 tone volume.
+1 or higher: Increases the Upper 2 tone volume.
0: Upper 1 and Upper 2 volume the same.
• The setting range is –24 to +24.
4. To return to the screen you were at prior to
step 1 of this procedure, press EXIT button.
You can use the procedure below to change the octave
of each layer.
1. Hold down the LAYER button until the screen
shown below appears.
2. Use the q and w arrow buttons to select
the layer whose octave you want to change.
• Upper 1: Select “Upper1 Octave”
Upper 2: Select “Upper2 Octave”.
3. Use the u (–) and i (+) arrow buttons to
change the octave.
• +1 or higher: Raises the octave by the specified value.
–1 or lower: Lowers the octave by the specified value.
0: Returns the octave to its original setting.
• The setting range is –2 to +2.
4. To return to the screen you were at prior to
step 1 of this procedure, press EXIT button.
To adjust the volume balance between
two layered tones
 L a y e r B a l a n c e
To change the octave of each layer