User manual
Table Of Contents
- CHAPTER 1. BEFORE USING
- CHAPTER 2. BASIC OPERATION
- BASIC OPERATION
- TURNING THE PHONE ON AND OFF
- MENU ACCESS
- MENU SUMMARY
- MAKING A CALL
- ABOUT PUSH TO TALK
- TURNING PTT ON/OF
- USING A PUSH TO TALK (PTT) ALERT
- USING A PUSH TO TALK (PTT) BARGE
- ANSWERING CALLS
- ANSWERING PTT CALLS
- ENDING A CALL
- MISSED CALL NOTIFICATION
- WAIT/PAUSE
- MAKING AN INTERNATIONAL CALL
- 3 WAY CALLING
- CALL WAITING
- VOLUME QUICK ADJUSTMENT
- CALLER ID
- VIBRATE MODE
- MUTE FUNCTION
- SPEAKERPHONE
- FLASHLIGHT
- VOICE DICTATION
- TEXT TO SPEECH
- AVAILABLE OPTIONS DURING A CALL
- MAKING AN EMERGENCY CALL
- MOTION DETECTION
- BASIC OPERATION
- CHAPTER 3. MEMORY FUNCTION
- CHAPTER 4. MENU FUNCTION
- CHAPTER 5. SAFETY AND WARRANTY
- SAFETY AND WARRANTY
- SAFETY INFORMATION FOR WIRELESS HANDHELD PHONES
- GENERAL SAFETY
- SAFETY INFORMATION FOR FCC RF EXPOSURE
- SAR INFORMATION
- HEARING AID COMPATIBILITY (HAC) FOR WIRELESS TELECOMMUNICATIONS DEVICES
- TELETYPEWRITER (TTY) DEVICES
- FDA CONSUMER UPDATE
- EMERGENCY CALLS
- COMPLIANCE WITH OTHER FCC REGULATIONS
- AVOID POTENTIAL HEARING LOSS
- FCC COMPLIANCE INFORMATION
- RECYCLE YOUR CELL PHONE!
- 12 MONTH LIMITED WARRANTY
- SAFETY AND WARRANTY
24
02
03
04
05
01
25
REMOVING THE BATTERY
1. Slide the battery cover latch to the FREE
position in the direction of the arrow as
shown in the figure.
2. Insert your thumb in the right side groove
and pull up the battery cover in the direction
of the arrow.
3. Remove the battery by pulling the tab up.
Do not leave the removed battery in direct sunlight, or near heat sources such as an
open flame or stove. Otherwise, it may malfunction or cause a fire by bursting or
igniting. Do not hit, or exert excessive shock on the battery, as it can ignite or break.
CHARGING THE BATTERY
1. Connect the USB cable into the Wall/USB
Charger.
2. Plug the USB cable into the phone’s Charging/
Data Port. Plug the Wall/USB Charger into an
electrical outlet. The battery starts charging.
3. Disconnect the charger when the battery is
fully charged.
•
Hold the small connector with the USB mark facing up. When inserting the
connector into the Charging/Data Port on the handset, hold the connector straight
against the port without tilting it vertically or horizontally and gently insert it.
If the battery connector is not properly aligned, damage could occur to the charging
connector and the phone may not be charged.
• Failure to completely reseal the Charging/Data Port cover after charging may allow
water or other liquids to enter the casing, damaging the handset.
Correct Incorrect
Correct Incorrect