MA0406-EA Operation Guide IDR-200 ILLUSTRATION Main unit o C/oF SET SELECT 1cm RE-SYNC RESET WAVE o C/oF SET RESET SELECT RE-SYNC WAVE 1
Operation Guide IDR-200 Sub-unit • A sticker is affixed to the glass of this clock when you purchase it. Be sure to remove the sticker before using the clock. • Depending on the clock model, the configuration of your clock may differ somewhat from that shown in the illustration.
Operation Guide IDR-200 TIME CALIBRATION SIGNAL RECEPTION PRECAUTIONS USING THE CLOCK • This clock is able to receive the time calibration signal transmitted from Mainflingen, Germany (located 25kilometers southeast of Frankfurt). Mainflingen Signal reception is possible within approximately 1,200 km of the 1200 km transmitter.
Operation Guide IDR-200 Setting the Time and Date Manually • When using the clock in an area that is outside of the range of the transmitter in Mainflingen or in an area where signal reception is impossible for some reason, you need to manually adjust the time as required. 1. Press the SET button (2) to cycle through the setting screens as shown below.
Operation Guide IDR-200 Switching between Main Unit and Sub-unit Temperature Data • Press the SELECT button (7) to toggle the display between the main unit (INDOOR) temperature and the subunit (OUTDOOR) temperature. Main unit temperature: INDOOR indicator displayed Sub-unit temperature: OUTDOOR indicator displayed • The display does not change to the sub-unit (OUTDOOR) temperature if no data has been received from the subunit yet.
Operation Guide IDR-200 MAIN UNIT/SUB UNIT COMMUNICATION PRECAUTIONS Sub Unit Location • Certain environmental conditions can greatly reduce the communication range. • Avoid the following locations for the sub-unit.
