Operation Manual

E-33
Part 9 Frames
The frame feature makes it easy to add attractive ornamental frames to your
text.
To specify a frame around the printing area
1. Input the text you want to frame.
2. Press FRAME.
3. Use u, i, t and y to move the highlight-
ing to the frame you want to use and press
SET.
4. Press SET to print your text with the selected frame or ESC to abort the print
operation without printing anything.
• For information about the maximum number of lines you can use with frame
printing, see “To input alpha-numeric characters” on page E-13.
Part 10 PRESETS Menu Functions
This part of the manual describes how to use the PRESETS menu to access a
variety of different built-in functions that make label creation quicker and easier.
To Display the PRESETS Menu
1. Press PRESETS.
• Note that PRESETS menu functions are normally used when there is no text
on the input screen. If there is text on the screen when you press PRESETS,
the message “INPUT TEXT WILL BE CLEARED! OK TO CONTINUE? SET/
ESC” appears on the screen. You can proceed with the operation (and clear
the text), or press ESC to abort without clearing anything.
2. Use u and i to move the highlighting to the preset you want to select and
then press SET.
Enlarge
This item lets you print up to 16 characters on multiple tapes, which you can
then assemble into an enlarged label. The character size on such a label can
be up to about 180mm. Note that this item is available only when 36 or 46mm
tape is loaded in the label printer. See page E-42 for important information
about character sizes and tape width when using the various settings of this
item.
• You cannot use less than 36mm width tape or colored tapes.