Operation Manual

E-35
EAN-13, EAN-8, UPC-A, UPC-E
The following applies to EAN-13, EAN-8, UPC-A, and UPC-E bar codes.
To print a bar code
1. While the PRESETS menu is on the display, use u and i to move the
highlighting to “BAR CODE” and then press SET.
2. Use u and i to move the highlighting to
“NEW” and then press SET.
3. Use u and i to move the highlighting to
the type of bar code you want to print and
then press SET.
4. Input up to 60 characters of comment text if you want, and then press SET.
5. Input the bar code’s data and then press SET.
• The number of digits you must input depends on each type of bar code you
have chosen. (See “Bar Code Specifications” on page E-43)
• Note that inputting barcode data automatically turns on upper-case input.
6. Use u and i to move the highlighting to
the size you want to use and then press SET.
7. Use u and i to move the highlighting to “PRINT” and then press SET to
execute it.
8. Use u and i to move the highlighting to “EXIT” and then press SET.
9. Press SET to end the operation.
ITF, CODE39, CODABAR
The following applies to ITF, CODE39 and CODABAR bar codes.
To print a bar code
1. While the PRESETS menu is on the display, use u and i to move the
highlighting to “BAR CODE” and then press SET.
2. Use u and i to move the highlighting to “NEW” and then press SET.
3. Use u and i to move the highlighting to
the type of bar code you want to print and
then press SET.
4. Use u and i to select “YES” (use check digit) or “NO” (do not use check
digit) and then press SET.
5. Input up to 60 characters of comment text if you want, and then press SET.
6. Input the bar code’s data and then press SET.
7. Perform steps 6 through 9 under “To print a bar code” of “EAN-13, EAN-8,
UPC-A, UPC-E”.
General Bar code Operations
The following procedures apply to all bar code types.
To store a bar code
1. Perform the required steps to create the bar code so the following is on the
screen.
2. Use u and i to move the highlighting to “STORE” and then press SET.
3. Input up to eight characters for the name of the bar code, and then press
SET.
4. Press SET to store the bar code or ESC to abort the operation without stor-
ing anything.
• The message “COMPLETE” appears on the display when the store operation
is complete.
5. Use u and i to move the highlighting to “EXIT” and then press SET.
6. Press SET to end the operation.