User Manual
Operation Guide 3467
E-59
Specifying the Illumination Duration
You can select either 1.5 seconds or three seconds as
the illumination duration.
1. Enter the Timekeeping Mode.
Navigating Between Modes…E-12
2. Hold down A for at least two seconds. Release the
button when [SET] stops flashing.
3. Press C nine times to display [LT].
E-58
Illumination Light
The watch has an LED light that you can turn on for
reading in the dark.
Illuminating the Face Manually
Pressing B turns on illumination.
x The LED light will turn off automatically if the alarm starts
to sound.
E-57
Determining an Alarm’s On/Off Status
Turning on an alarm or the hourly time signal causes the
corresponding indicator to appear on the display. The
alarm on indicator is displayed when one or more alarm
is turned on.
Hourly time signal
Alarm
E-56
2. Press E to toggle the displayed alarm or the
hourly time signal between on and off.
[On]: On
[
–
–]: Off
Stopping an Alarm
Pressing any button while the beeper is sounding stops it.
E-55
Enabling/Disabling an Alarm or the Hourly Time Signal
1. Press D to scroll through alarm numbers ([AL1] to
[AL5]) and the hourly time signal ([SIG]) screens until
the one you want to configure is displayed.
Alarm or hourly
time signal
E-54
4. Press C.
This causes the minute digits to flash.
5. Use D and E to change the minute setting.
6. Press A to exit the setting screen.
Note
x A beeper will sound for 10 seconds to let you know
when the alarm time is reached.
Minutes
E-53
2. Hold down A for at least two seconds. Release the
button when the hour digits start to flash.
3. Use D and E to change the hour setting.
x If you are using 12-hour timekeeping, [P] indicates
p.m.
Hours
E-52
Alarms and Hourly Time Signal
The watch will beep when an alarm time is reached. You can set up to five different
alarms. The hourly time signal causes the watch to beep every hour on the hour.
● Getting Ready
Enter the Alarm Mode.
Navigating Between Modes…E-12
Configuring Alarm Settings
1. Press D to scroll through alarm numbers ([AL1]
to [AL5]) until the number of the alarm you want to
configure is displayed.
Alarm number
E-51
Before swapping
Dual Time
After swapping
Current location time
Current location time Dual Time
E
Note
x This function comes in handy when you need to move to another time zone.
E-50
3. Press C.
This causes the minute digits of the Dual Time to flash.
4. Use D and E to change the minute setting.
x You can change the setting in 15-minute increments.
5. Press A to exit the setting screen.
Swapping Your Current Location Time and Dual Time
1. Enter the Dual Time Mode.
Navigating Between Modes…E-12
2. Hold down E for at least two seconds.
This swaps your current location time and Dual Time.
Minutes