Operation Guide

Performing a Stopwatch
Measurement with a Target
Time
You can perform lap time measurement
operations while checking the difference
between the lap time and a target time.
● Using a Stopwatch Target Time
Specifying a Target Time
You can specify one of three target times.
FASTEST :
Following start of a stopwatch elapsed time
measurement session, the fastest measured
lap time of the current session is automatically
set as the target time.
TARGET :
You can use EDIFICE Connected to specify a
desired target time.
If you use the watch without connection with a
phone, the target time is automatically set to
15 minutes.
LAST :
Following start of a stopwatch elapsed time
measurement session, the last measured time
of the current session is automatically set as
the target time.
1.
Hold down (A) for at least two seconds.
2. Press (E) to cycle through the target time
types.
3. Press (A) to exit the setting screen.
Measuring Elapsed Time
Each time you press (E) to measure a lap time,
the second hand indicates the difference
between the lap time and the target time.
E
E
E
E
A
Lap 1
Start
Stop
Lap 2
Lap 3
[TARGET] Target Time Type :
You can check the difference between the
measured lap time and the target time from the
first lap onwards.
[FASTEST] or [LAST] Target Time Type :
You can check the difference between the
measured lap time and the target time from the
second lap onwards.
●
Interpreting the Difference with the
Target Time
The difference between a lap time and the
target time is indicated by the second hand.
The time difference is indicated in the area
from 9 o’clock to 5 o’clock.
30 or more
seconds fast *
1
20 seconds fast
10 seconds fast
5 seconds fast
Same as
target time
10 or more seconds slow *
2
5 seconds slow
*1 If the lap time is 30 or more seconds faster
than the target time, the second hand will be
at the 9 o’clock position.
*2 If the lap time is 10 or more seconds slower
than the target time, the second hand will be
at the 5 o’clock position.
● Target Time Beep Alert
You can use the procedure below to configure
a setting so the watch sounds a tone when the
lap time reaches the target value during
measurement.
1. Hold down (A) for at least two seconds.
●
This displays the target time setting
screen.
2. Press (D).
●
This displays the beep alert setting
screen.
3. Press (E) to change the beep alert setting.
[♪ON]: Beep alert enabled.
[♪OFF]: Beep alert disabled.
4. Press (A) to exit the setting screen.
Example: Recording a Race
Lap Time
This section explains how to measure lap
times while watching a race, and check the
difference between a lap time and target time.
It also shows how you can view lap times with
EDIFICE Connected after the race is over.
l
Lap Times
Before a race
At this time, you should specify the target time
type. If you specify TARGET as the target
value type, you should also specify the
TARGET time.
l
Using EDIFICE Connected to Change the
Target Time Type
l
Using Watch Operations to Change the
Target Time Type
l
Configuring TARGET Time Settings
During a race
Measure lap times.
1.
X
Hold down (D) for at least two seconds.
This will cause the watch to enter the
Timekeeping Mode.
2.
X
Press (D) once.
This will cause the watch to enter the
Stopwatch Mode.
Lap evaluation
Speed
Minutes, seconds, 1/1000 seconds
Operation Guide 5537
11