Operation Guide

3.
X
Use the operations below to measure
lap times.
E
E
E
A
Stop
Start
Pressing (E) at the end of each lap will
record each lap time in watch memory.
●
Lap times are recorded in 1/1000-
second units during the first hour of an
elapsed time measurement session.
After one hour, times are recorded in
1/10-second units.
●
The difference between a lap time and
a target time specified by you is
indicated by the second hand.
l
Interpreting the Difference with the
Target Time
4.
X
Press (A) to reset the stopwatch time to
all zeros.
5.
X
Hold down (D) for at least two seconds
to return to the Timekeeping Mode.
After a race
After the race is finished, you can view the
measured lap times with EDIFICE Connected.
l
Sending Stopwatch Data to a Phone
l
Checking a Lap Time
Viewing Measured Data
Records
You can use the procedure below to view lap
time records.
1. Enter the Recall Mode.
l
Navigating Between Modes
2. Use (E) to cycle through lap numbers.
●
Each press of (E) advances
sequentially through the lap numbers
from [L01] to [200].
E
E
E
E
Lap number
3. Press (A) to display the lap time of the
currently displayed lap number.
Note
●
Lap time records in watch memory are
lap time measurements taken during a
single stopwatch elapsed time
measurement session (start of time
measurement from all zeros, up to the
point stopwatch time is reset to all
zeros). Records are assigned
numbers in the sequence the lap time
measurements are performed.
Lap Times
A lap time shows the time elapsed during a
specific lap. The stopwatch normally shows
the ongoing elapsed time measurement from
the beginning of the race. The current lap time
is kept internally by the watch, and is not
displayed until you press (E). The difference
between the current lap time and the target
time is also indicated.
E
Start
E
Lap 1
E
A
Goal
Lap 2
Lap 3
Note
●
Lap times can be viewed with EDIFICE
Connected after measurement is
complete.
l
Viewing Stopwatch Data
Timer
The timer counts down from a start time
specified by you. A beeper sounds when the
end of the countdown is reached.
●
The beeper is muted in the cases described
below.
ー
When battery power is low
Getting Ready
Enter the Timer Mode.
l
Navigating Between Modes
Operation Guide 5537
12