Operation Guide
Table Of Contents
- Before Getting Started...
- Using Mobile Link with a Mobile Phone
- Stopwatch
- Timer
- Alarms and Hourly Time Signal
- World Time
- Adjusting Time Settings Manually
- Light
- Hand Alignment Adjustment
- Other Settings
- Moving to Another Time Zone
- Other Information
- Troubleshooting
3. Use (E) to select [KEY♪] or [MUTE].
[KEY♪]: Operation tone enabled.
[MUTE]: Operation tone muted.
4. Press (A) to exit the setting screen.
Note
●
Note that alarm and timer tones will still
sound even while the operation tone is
muted.
Configuring Power Saving
Function Settings
1. Hold down (A) for at least two seconds
until the name of the currently selected
Home City is displayed.
Home City
2. Press (D) 15 times.
This displays [P.SAVE].
3. Press (E) to toggle the setting between
enabled (on) and disabled (off).
[ON]: Power Saving enabled.
[OFF]: Power Saving disabled.
4. Press (A) to exit the setting screen.
Note
●
For details about Power Saving, refer
to the information below.
l
Power Saving Function
Resetting Watch Settings
This section explains how to return the watch
settings below to their initial factory defaults.
●
Watch Settings
●
Stopwatch
●
Timer
●
Alarm
1. Hold down (A) for at least two seconds
until the name of the currently selected
Home City is displayed.
Home City
2. Press (D) twice.
This causes the seconds to flash.
Seconds
3. Hold down (B) for at least five seconds.
Release the button when [RESET] stops
flashing.
Note
●
Resetting the watch will also delete
information for pairing the watch with a
phone, and unpair them.
Moving to Another Time
Zone
Use the procedure below to easily change day
and time settings of the watch to a destination
location.
● Before Boarding
1. Configure the World Time to the current
time at your destination.
Current time
Destination time
l
Using EDIFICE Connected to
Configure Settings
l
Using Watch Operations to Configure
Settings
2. Disable auto time adjustment.
l
Using the Watch in a Medical Facility or
Aircraft
● In the aircraft, before arriving at your
destination
1.
Swap the origin time zone time with the
destination time zone time.
Before swapping After swapping
Destination time
Destination time
l
Using EDIFICE Connected to
Configure Settings
l
Using Watch Operations to Configure
Settings
● After Arriving
1.
Enable auto time adjustment.
l
Using the Watch in a Medical Facility or
Aircraft
2. Adjust the time setting.
l
Triggering Immediate Time Adjustment
Operation Guide 5537
19