Operation Guide

Configuring Stopwatch
Settings
You can use the procedures in this section to
specify a target time for comparison with lap
times measured in the Stopwatch Mode. You
can also enable or disable the beep that
sounds when your current lap time matches
the target time.
l
Performing a Stopwatch Measurement with
a Target Time
l
Lap Times
● Specifying the Target Time Type
You can specify one of the target time types
described below, which are used to calculate
the difference between your target time and
actual lap time measurements.
FASTEST :
Following start of a stopwatch elapsed time
measurement session, the fastest measured
lap time of the current session is automatically
set as the target time. Resetting the stopwatch
to all zeros will clear this target time.
TARGET :
You can use EDIFICE Connected to specify a
desired target time.
LAST :
Following start of a stopwatch elapsed time
measurement session, the last measured time
of the current session is automatically set as
the target time. Resetting the stopwatch to all
zeros clear this target time.
1.
Y
Tap the “EDIFICE Connected” icon.
2.
X
Hold down (C) for at least 1.5 seconds
until [CONNECT] starts to flash.
When a connection is established
between the watch and phone,
[CONNECT] will stop flashing and the
second hand will move from [R] to
e
.
●
If connection fails for some reason,
[ERR] will appear on the display
momentarily and then the watch will
return to the mode it was in before you
started the connection procedure.
Trying to connect
Connected
3.
Y
Perform the operation shown on the
phone screen to specify a target time type.
Note
●
If you specified TARGET as the target
time type, you should also specify the
target time.
l
Configuring TARGET Time
Settings
●
Changing the target time type while a
stopwatch measurement operation is
stopped will reset the stopwatch time
to all zeros.
● Configuring TARGET Time Settings
If you specified TARGET as the target time
type, perform the procedure below to specify
the target time.
●
The TARGET time value must be 30
seconds or greater.
1.
Y
Tap the “EDIFICE Connected” icon.
2.
X
Hold down (C) for at least 1.5 seconds
until [CONNECT] starts to flash.
When a connection is established
between the watch and phone,
[CONNECT] will stop flashing and the
second hand will move from [R] to
e
.
●
If connection fails for some reason,
[ERR] will appear on the display
momentarily and then the watch will
return to the mode it was in before you
started the connection procedure.
Trying to connect
Connected
3.
Y
Perform the operation shown on the
phone screen to specify the TARGET
time.
Note
●
Changing the TARGET time while a
stopwatch measurement operation is
stopped will reset the stopwatch time
to all zeros.
● Enabling or Disabling Alert Sounds
You can configure a setting so the watch
beeps when the lap time reaches the target
time during measurement.
1.
Y
Tap the “EDIFICE Connected” icon.
2.
X
Hold down (C) for at least 1.5 seconds
until [CONNECT] starts to flash.
When a connection is established
between the watch and phone,
[CONNECT] will stop flashing and the
second hand will move from [R] to
e
.
●
If connection fails for some reason,
[ERR] will appear on the display
momentarily and then the watch will
return to the mode it was in before you
started the connection procedure.
Trying to connect
Connected
3.
Y
Perform the operation shown on the
phone screen to enable or disable the alert
sound.
Note
●
Changing the alert sound setting while
a stopwatch measurement operation is
stopped will reset the stopwatch
measurement value to all zeros.
Operation Guide 5537
6