Operation Guide

Note
●
Auto time adjustment does not work for
24 hours after swapping of the Home
Time and World Time.
Adjusting Hand and Day
Indicator Alignment
If the hands and/or date indicator are out of
alignment even though auto time adjustment
is being performed, use OCEANUS
Connected to adjust them.
1.
Y
Tap the “OCEANUS Connected” icon.
2.
X
Hold down (C) for about four seconds.
This causes the second hand to move to
[C] and establishes a connection between
the watch and phone.
3.
Y
Perform the operation shown on the
phone screen to correct hand and day
indicator alignment.
Note
●
The movement of some hands are
linked with other hands. When
correcting the alignment of such a
hand, you will have to correct the
alignment of the linked hand(s) at the
same time.
Phone Finder
You can use phone finder to trigger a tone on
the phone to make it easy to find. The tone is
forced to sound even if the phone is in vibrate
mode.
Important!
●
Do not use this function in areas where
phone call tones are restricted.
●
The tone sounds at a high volume. Do
not use this function when listening to
phone output over earphones.
1.
X
If the watch is connected with a phone,
press any button to terminate the
connection.
3030
DisconnectedConnected
2.
X
Hold down (C) for about two seconds.
This will cause the watch to enter the
Timekeeping Mode.
3.
X
Hold down (B) for about 3.5 seconds
until the second hand points to [C].
A connection will be established between
the watch and phone, and then the
phone’s ringtone will sound.
●
It will take a few seconds before the
phone tone sounds.
4.
X
Press any button to stop the tone.
●
You can press any watch button to stop
the phone tone, but only during the first
30 seconds after it starts to sound.
Configuring Watch Settings
You can use OCEANUS Connected to specify
the amount of time until the Bluetooth
connection is automatically terminated, and to
configure other watch settings.
1.
Y
Tap the “OCEANUS Connected” icon.
2.
X
Hold down (C) for about four seconds.
This causes the second hand to move to
[C] and establishes a connection between
the watch and phone.
3.
Y
Select the setting you want to change
and then perform the operation shown on
the phone screen.
Changing the Home City
Summer Time Setting
1.
Y
Tap the “OCEANUS Connected” icon.
2.
X
Hold down (C) for about four seconds.
This causes the second hand to move to
[C] and establishes a connection between
the watch and phone.
3.
Y
Perform the operation shown on the
phone screen to change your Home City
summer time setting.
Checking the Watch Charge
Level
Use the procedure below to check the current
charge level with OCEANUS Connected.
1.
Y
Tap the “OCEANUS Connected” icon.
2.
X
Hold down (C) for about four seconds.
This causes the second hand to move to
[C] and establishes a connection between
the watch and phone.
3.
Y
Use OCEANUS Connected to check the
charge level.
Operation Guide 5542
10