Hardware manual

• Terminal layout

123 456123 456

Fig 2.1

• Terminal layout and the description

Table 2.4

Terminal no. Signal Description Direction

1 V BUS Power from USB cradle OUT/IN (see note)

2 V CRADLE Power supply/Charge to IT-600 -

3 D + USB D + IN/OUT

4 USB_ID Switch-over between USB host and USB client IN

5 D - USB D - IN/OUT

6 GND GND -

Note:

When the selector switch on the HA-D60IO is set to “USB Host”, this terminal receives the power

ON/OFF control signal issued by the IT-600. Or, when it is set to “USB Client”, the terminal

outputs the USB power (V BUS) to the IT-600.