Hardware manual

26
• Terminal layout
123 456123 456
Fig 2.2
• Terminal layout and the description
Table 2.6
Terminal no. Signal Description Direction
1 V BUS Power from USB cradle IN/OUT (see note)
2 V CRADLE Power supply/Charge to IT-600 -
3 D + USB D + IN/OUT
4 USB_ID Switch-over between USB host and USB client OUT
5 D - USB D - IN/OUT
6 GND GND -
Note:
When the selector switch on the HA-D62IO is set to “USB Host”, this terminal receives the power
ON/OFF control signal issued by the IT-600. Or, when it is set to “USB Client”, the terminal
outputs the USB power (V BUS) to the IT-600.