User Manual

E-85
Useful features
Advanced programmings and registrations
Programming functions of PLUs individually
This part explains programming methods of each function of PLUs individually.
Step Operation
1 Turn the Mode switch to PGM position and select [System
Setting] then press F key.
>▪▪▪▪▪>F
2 Enter 3 and press o key to set the register in the
programming mode.
3o
3 Referring the tables in the proceeding section, enter two-
digit set code you wish to program followed by two 6s. The
“66” is the identication code for individual programming of
departments and PLUs. Then press o key.
BB66o
(set code)
4 Enter PLU number you wish to set and press
PLU/
S.DEPT
key. 0005
PLU/
S.DEPT
This example is for setting a program in PLU
0005.
5 Referring the table in the preceding section, enter program
code and press F key.
B▪▪▪▪▪BF
(Program code)
6 If you wish to set the same program code in the next PLU
number, press F key again.
Perform step 5 if you wish to set another program code to
the next PLU number.
To program in another PLU number (not next PLU number),
repeat steps 4 and 5.
F
7 Press o key to complete the settings.
o
Example 1: To set PLU 0001 as “Open PLU”.
Press 3o0466o0001
PLU/
S.DEPT
4Fo
Example 2: To set PLU0012 to link item group 12 and dept. 04.
Press 3o1166o0012
PLU/
S.DEPT
0120004Fo