User Manual

Operations Common to All Modes
EN-10
1. Hold down 6 a.
• Do not release 6 a until step 3, below.
2. Use keyboard keys C1 to A1 to input a song
number.
• Input two digits for the song number.
3. After entering the song number, release
6 a.
When you perform a touch button and keyboard key
combination operation (page EN-9), a notification tone will
sound when you press the keyboard key to let you know the
result of the operation. Notification tone types are described
below.
■ Notification Tone Types
■ Notification Tone Sets
Your Digital Piano comes with three different notification tone
sets from which you can choose. You can also disable
notification tones, if you want. For information about how to
change the notification tone set, see “Other Settings” (page
EN-45).
Inputting Song Numbers Using
the Song Selection Keyboard
Keys (10-key)
Song Number Songs
1 to 60 Built-in Music Library Songs
61 to 70 User Songs
71 MIDI Recorder Song
C1
A0
C2 C3 C4 C5 C6 C7
C8
024579
13 68
C1 C{1D1 E1 F1 G1A}1F{1A1E}1
Notification Tones
This type of
tone sounds:
When this happens:
Received
tone
A keyboard key operation is received and
applied. This tone sounds if a setting is
enabled (turned on) when you press a
keyboard key that toggles the setting
between enabled and disabled.
Invalid tone You press the wrong keyboard key. This
tone lets you know the operation is invalid.
Upper limit,
lower limit
tone
You press a keyboard key that would cause
the setting to become greater than the
upper limit or less than the lower limit.
Initialization
tone
Settings were returned to the initial defaults.
This tone sounds when you press the plus
(+) and minus (–) keyboard keys at the
same time, etc.
Option tone A setting option is changed by pressing a
keyboard key that cycles through options.
The number of times the tone sounds
depends on the option that is selected.
Off tone A setting is disabled (turned off).
Reference
tone
As you use the plus (+) and minus (–)
keyboard keys to change a setting value, a
reference tone will sound to signal when the
keyboard key operation result in certain
types of values to be set. In the case of
whole number (non-fraction) values, the
reference tone will sound whenever the
setting becomes one that is multiple of 10
(10, 20, etc.) In the case of fraction values
(like 440.2), the reference tone will sound
whenever the setting becomes a value that
is a whole number (440, 441, etc.)
End tone The final keyboard key was pressed for a
setting operation that requires multiple
keyboard key operations. For example,
when you input a three-digit tempo setting,
this tone will sound when you press the
keyboard key for the third digit.