User Manual

EN-7
Overview and Setup
■ Power On Alert
After about six minutes of non-operation while the Digital
Piano is being powered by its AC adaptor, the Power On Alert
function will cause touch button lights to turn on and off
sequentially to remind you that power is on. Button lights will
return to normal (all button lights lit) if you touch a button, play
something on the keyboard, or perform some other operation.
To turn off power, hold down the 1P (Power) button until all
lit touch button lights turn off.
• You can enable or disable the power on reminder as
required. See “Other Settings” (page EN-45).
• If you are using batteries to power the Digital Piano, power
will turn off automatically after about six minutes of non-
use. See “Auto Power Off” (page EN-7).
■ Returning to Initial Factory Defaults
You can use Factory Reset (Initialization) to return the Digital
Piano’s stored data and settings to their initial factory defaults
any time you want. For more information, see “Factory Reset
(Initialization)” (page EN-47).
This Digital Piano is designed to turn off automatically to avoid
wasting power after no operation is performed for a preset
amount of time. The Auto Power Off trigger time is about four
hours when power is being supplied by the AC adaptor, or six
minutes under battery power.
• You can disable Auto Power Off to ensure that power does
not turn off automatically during a concert, etc. To disable
Auto Power Off, perform the procedure below.
■ To enable or disable Auto Power Off
1. While holding down 3 FUNCTION, press the
B}0 keyboard key.
• Each press of the B}0 keyboard key sounds a
notification tone and toggles Auto Power off between
enabled and disabled. For more information, see
“Notification Tones” (page EN-10).
2. After the setting is the way you want, release
3 FUNCTION.
Connect the supplied pedal (SP-3) to the bm DAMPER
PEDAL jack.
Back
This pedal functions as a damper pedal under initial Digital
Piano default settings. To change it to a different function
(soft, sostenuto, etc.), see “Changing Pedal Functions” (page
EN-44).
■ PEDAL UNIT Jack
You can connect the optionally available 3-Pedal Unit (SP-34)
to the bn PEDAL UNIT jack on the back of the Digital Piano.
You can then use the pedals for expression that is similar to
that available on an acoustic piano.
SP-34 Pedal Functions
● Damper Pedal
Pressing the damper pedal while playing will cause the notes
you play to reverberate. The SP-34 pedal also supports half-
pedal operation, so pressing the pedal part way applies only a
partial damper effect.
● Soft Pedal
Pressing this pedal suppresses notes played on the keyboard
after the pedal was pressed, and makes them sound softer.
● Sostenuto Pedal
Only the notes of the keys that are depressed when this pedal
is pressed are sustained, even if the keyboard keys are
released, until the pedal is released.
• A separately available pedal unit can be used at the same
time as the supplied pedal.
Auto Power Off
B}0
C1A0 C2 C3 C4 C5 C6 C7 C8
Using a Pedal
bm DAMPER PEDAL jack (Standard jack (6.3mm))
SP-3
Soft Pedal
Sostenuto Pedal
Damper Pedal