User Manual

EN-2
Connection requires commercially available connecting cords,
supplied by you.
• The connecting cords should have a 3-pole stereo mini plug
on one end and a plug that matches the configuration of the
external device on the other end.
• Turn off the external device when making connections.
After connecting, turn down the Digital Piano and
external device volume levels whenever turning power
on or off.
• After connecting, turn on the external device and then
the Digital Piano.
• If external device notes that sound through the Digital
Piano speakers are distorted, lower the external
device’s volume level setting.
When you are playing audio from an external source through
the Digital Piano’s speakers, you can adjust the volume level
and even perform center cancel, which cuts the vocal part.
These operations are available for audio input using Bluetooth
or the Digital Piano’s ct AUDIO IN jack.
■ Center Cancel (Vocal Cut)
Enabling center cancel cuts the vocal part from the audio
being input using Bluetooth or the Digital Piano’s ct AUDIO
IN jack. Note that this function cancels the sound in the center
position of the audio, which may (depending on how the
original audio was mixed) end up canceling something else
other than the vocal part. How vocal cut is performed depends
on the sound being input.
■ To adjust the volume of external input
1. Hold down the bp^ button until “[FUNCTION]”
appears on the display.
This enters the FUNCTION Mode.
2. Use the bk U and bl I buttons to display
“AUDIO IN” and then touch bm ENTER.
3. Use the bk U and bl I buttons to display
“Audio In Volume” and then touch bm ENTER.
4. Use the bk – and bl + buttons, or cm Knob
(K1) to change the setting.
• You can set the volume within the range of 0 to 127.
• To return to the initial default setting, touch bk – and
bl + at the same time.
5. To exit the FUNCTION mode, hold down
bp EXIT until “[FUNCTION]” disappears from
the display.
■ To change the center cancel setting
1. Perform steps 1 and 2 under “To adjust the
volume of external input”.
2. Use the bk U and bl I buttons to display
“Center Cancel” and then touch bm ENTER.
3. Use bk – or bl + to switch the setting between
“On” (center cancel enabled) and “Off” (center
cancel disabled).
4. To exit the FUNCTION mode, hold down
bp EXIT until “[FUNCTION]” disappears from
the display.
Playing Sound from External
Audio Equipment Through the
Digital Piano’s Speakers
3-pole stereo mini plug
ct AUDIO IN jack (Stereo mini jack (3.5mm))
Portable audio player, etc.
External Input Volume
Adjustment and Center Cancel