User manual - 074H_midi

Message Format: AnH kkH vvH
n: MIDI Channel Number
kk: Key Number
vv: Pressure Value
Send This message is not sent by this Instrument.
Receive This message is not received by this Instrument.
10 Control Change
Message Format: BnH ccH vvH
n: MIDI Channel Number
cc: Control Number
vv: Value
Send Sent when the Instrument’s pedal is op erated or when Instrument settings are changed.
Receive Receipt changes the pedal and other performance conditions, and Instrument settings.
Drawbar Operation by Control Change Message When a drawbar tone is selected on the ap-
plicable MIDI channel (n: MIDI Channel Number), control change messages can be used to perform
various drawbar parameter operations. (Drawbar tone selection is supported by the CTK-7200, CTK-
7300, WK-7600 only.) Specifically, control change message assignment can be switched as shown below
when a non-drawbar tone is selected or when a drawbar tone is selected.
Control Change Numb er Non-drawbar tone selected Drawbar tone selected
46H - Drawbar Position 16’
47H - Drawbar Position 5 1/3’
48H Release Time Drawbar Position 8’
49H Attack Time Drawbar Position 4’
4AH Filter Cut Off Drawbar Position 2 2/3’
4BH - Drawbar Position 2’
4CH Vibrato Rate Drawbar Position 1 3/5’
4DH Vibrato Depth Drawbar Position 1 1/3’
4EH Vibrato Delay Drawbar Position 1’
4FH - Drawbar Organ Typ e
54H - Drawbar Organ 2nd Percussion
55H - Drawbar Organ 3rd Percussion
56H - Drawbar Organ Percussion Decay Time
57H - Drawbar Organ Key On Click
58H - Drawbar Organ Key Off Click
59H - Vibrato Rate
5AH - Vibrato Depth
For details about messages, see each section of this manual that covers them.
12