User Manual

46
Projector Network Settings
There are two types of projector network settings: basic settings that can be configured by the
projector alone, and more detailed settings that can be configured by using a computer connected to
the projector via a LAN connection to access the Projector Admin pages.
z For information about basic network settings that can be configured on the projector alone, see
“Using the Projector Setup Menu” (below).
z For information about using a computer web browser to configure detailed network settings, see
“Using the Projector Admin Pages” (page 52).
You can use the “Network Settings” main menu, which is included in the projector setup menu, to
display information about and configure settings for the projector and external device LAN
connection.
The table below shows the menu items included in the “Network Settings” main menu.
* Projector standby power consumption depends on whether or not Remote On is enabled. For
information about power consumption in each standby state, see the “Setup Guide” that comes
with the projector.
You can perform the following procedures on the projector itself or using the remote controller that
comes with the projector.
Using the Projector Setup Menu
Menu Item Description Refer to:
Wired LAN info
(XJ-M Series only)
Shows information about the current wired LAN
connection status (IP address, DHCP setting, etc.)
“To display wired LAN
information (XJ-M Series
only)” (page 47)
Wireless LAN Info Shows information about the current wireless LAN
connection (IP address, DHCP setting, security
settings, status of connection with external access
point, etc.)
“To display wireless LAN
information” (page 48)
Projector Wired LAN
Settings
(XJ-M Series only)
Configure the IP address setting. “To change the IP settings”
(page 50)
Projector Wireless LAN
Settings
Displays a dialog box for selecting the SSID and setting
the IP address for use when the projector is used as a
wireless LAN access point.
“To change the SSID” (page
49)
“To change the IP settings”
(page 50)
Remote On*
(XJ-M Series only)
Specifies whether the projector can be turned on via
LAN while the projector is in standby (projector off with
power being supplied).
–
PJLink Authentication
(XJ-M Series only)
Enables and disables PJLink connection
authentication.
–
Update Network Settings Reflects on the projector changes made to “Projector
Wireless LAN Settings”.
–
Initialize Network
Settings
Returns network settings to their initial factory defaults. “To initialize network
settings” (page 51)