User Manual

66
Control Panel Page Remote Control Items
Group Item Description
Refresh (Button) Click to refresh the screen with the latest information.
Projector Status Projector Status Shows the projector’s current status as either “ON” or “Standby”.
Error Info Shows one of the following.
No Error: Operating normally.
Temperature Error: Temperature error occurred.
Fan Error: Fan error occurred.
Light Error: Light source unit error occurred.
Other Error: Error other than above occurred.
Power Off (Button) Click to turn the projector off.
Power On (Button)
(XJ-M Series only)
Click to turn on the projector. This operation is supported only when
“Enable” is selected for “Remote On”.
Projector
Control
Input Specifies the input source.
3D
(XJ-M Series only)
Click to enter or exit the 3D input mode.
Color Mode Specifies the color mode.
Blank Selecting “ON” for this setting temporarily blocks the image from the
input source. “OFF” causes the image from the input source to be
projected.
Aspect Ratio Changes the aspect ratio of the projected image.
Brightness Input a value into the box and then click the [Apply] button. This will
change the projector’s “Brightness” setting accordingly.
Contrast Input a value into the box and then click the [Apply] button. This will
change the projector’s “Contrast” setting accordingly.
ECO Mode Switches the Eco mode.
Audio Volume Input a value into the box and then click the [Apply] button. This will
change the volume setting accordingly.
Mute Audio Specifies the mute setting. Audio is output while “OFF” is selected for this
setting, and muted when “ON” is selected.
Audio Out Specifies either output from the projector’s speaker or audio output
terminal for audio.
Speaker: Audio output from the speaker
Line: Audio output from the AV terminal (XJ-A Series) or AUDIO OUT
terminal (XJ-M Series)
Initialize (Button) Click to return all Network Projection Control items, except for the
“Projector Status” items, to their initial factory defaults.