User manual - User_Logo_Transfer_Guide_EN

6
CASIO Projector LOGO Loader Error Messages
Error Message Possible Cause and Required Action
There is a problem with the file
format.
ID-01
There may be something wrong with the logo header data.
Download the logo header data for your projector again and then perform the
procedure under “To transfer a user logo to the projector” again.
A connection could not be
established with the projector.
Check the USB cable connection,
turn the projector off and then
back on, and then try again.
ID-02
Could not connect with the projector. Check the points below.
z Is the USB driver installed on the computer? See “To install the USB
driver”.
z Is the USB cable connected correctly to the computer and the projector?
z Is the projector turned on?
This logo header file is for a
different model.
ID-04
The logo data cannot be transferred because it is for a different projector
model.
Go to the CASIO website and download logo data that is compatible with your
projector model, and then perform the procedure under “To transfer a user
logo to the projector” again.
The logo data was too large to
transfer.
Reduce the image size and try
again.
ID-05
The image file is too large (too many pixels). Use a file that is the appropriate
size as described under “User Logo Image Files”.
This type of image file is not
supported.
ID-06
The image file is not the correct type. Use a file that is the appropriate type as
described under “User Logo Image Files”.