User Manual

20
Use the procedure below to adjust the volume level of the projector’s speaker output, and output from
the AUDIO OUT terminal. If your projector does not have a built-in speaker, only AUDIO OUT terminal
output is affected.
To adjust the volume level
1. Press the [VOLUME +] or [VOLUME –] key.
 This causes the “Volume” screen to appear on the projected image.
2. Press the [VOLUME +] key to increase the volume, or the [VOLUME –] key to
lower the volume.
3. After the setting is the way you want, press the [ESC] key.
To mute the audio
1. Press the [VOLUME +] or [VOLUME –] key to display the “Volume” screen.
2. Press the [ENTER] key.
 This stops output from the speaker.
3. To restore the audio, press the [VOLUME +] or [VOLUME –] key.
Adjusting the Volume Level (VOLUME)