User Manual

27
One or more letters (such as RCV) after the menu item name indicates an item that is available only
when one or more particular input source is selected. The letters indicate the input source(s) where
the menu item is available.
R: RGB input, C: Component input, V: S-video input*
1
or Video input*
1
, H: HDMI (PC) input,
D: HDMI (DTV) input, F: File Viewer*
2
, T: CASIO USB Tool*
2
, N: Network*
2
, U: USB Display*
2
A menu item that does not have any letter after it will be available regardless of the input source.
after a menu item indicates the item is available only on XJ-F Series projectors.
after a menu item indicates the item is available only on network model projectors.
The initial default setting is indicated by an asterisk (*).
Setup Menu Settings
*1 XJ-F Series projectors only *2 Network model projectors only
Use this menu item: To do this:
Image Adjustment 1 3
Brightness
Adjust projected image brightness.
Image Adjustment 1 3
Contrast
Adjust projected image contrast.
Image Adjustment 1 3
Sharpness (V)
Use this sub-menu to adjust the sharpness of the outlines in the projected image. A
larger value makes the image sharper, while a smaller value makes it softer.
Image Adjustment 1 3
Saturation (V)
Use this sub-menu to adjust the color saturation of the projected image. A larger
value increases color saturation.
Image Adjustment 1 3
Tint (V)
Use this sub-menu to adjust the tint of the projected image.
A larger value makes the overall image more bluish, while a smaller value makes the
overall image more reddish. This setting is supported only when the signal is NTSC
or NTSC4.43.
Image Adjustment 1 3
Color Mode
Select one of the following projected image color modes: “Standard*”, “Graphics”,
“Theater*”, “Blackboard”, “Natural”.
Note
Initial default setting: “Theater” when the input source is S-Video, Video, or
HDMI (DTV). “Standard” any other time.
Image Adjustment 1 3
Color Balance
Select one of the following color balance presets: “Warm”, “Normal*”, “Cold”.
Also can be used to separately adjust red, green, and blue.
Image Adjustment 1 3
Light Control Off Mode
When “Off” is selected for the “Option Settings 1 3 Light Control 3 Light Control”
setting, specify either “Bright” (brightness priority) or “Normal*” (hue priority) as the
image quality setting.
Image Adjustment 1 3
Restore Menu Defaults
Return all of the items in the “Image Adjustment 1” main menu to their initial defaults
for the currently projecting image source.
Image Adjustment 2 3
Vertical Position (RCV)
Adjust the vertical and horizontal positions of the input source image in relation to
the target screen.
Image Adjustment 2 3
Horizontal Position (RCV)
Image Adjustment 2 3
Frequency (R)
When vertical bands appear in the projected image while RGB is selected as the
input source, it means that the frequency setting is not correct. When this happens,
use this setting to adjust the frequency manually. If, for some reason, your manual
frequency settings cause the image input from the computer to disappear from the
projection, you can press the [AUTO] key to perform an auto adjust operation, which
should cause the image to appear.
Image Adjustment 2 3
Phase (R)
Adjust the phase of the RGB input signal when the image flickers because the
projector phase and RGB input signal phase do not match.