User Manual

Configuring Other Settings
EN-18
4
Menu for configuring knob, fader, and button operation settings.
1
Fader Curve. Changes the fader curve of the MIX FADER. 00, 01, 02
2
Fader Assign. Assigns a function to the ASSIGNABLE fader.
Off: No function assigned, SCR: Scratch effect, BND: Pitch bender effect, EFT:
Effect
Off, SCR, BND,
EFT
3
Scratch Weight. Specifies how the scratch effect (SCR) is applied when it is
assigned to the ASSIGNABLE fader.
LT: Effect fully applied with small fader movement.
MID: Medium
HVY: Not much effect applied even with large fader movement.
LT, MID, HVY
4
Effect Knob Reflect. On: Applied effect depends on the current position of the
FX1 or FX2 knob. Off: Applied effect is the last effect applied or the initial default
effect.
Off, On
5
Effect Knob Target. Specifies the effects that are adjusted by the effect knob.
All: All effects
Lst: Last effect applied
All, Lst
6
Record Controller.
Specifies whether or not FX1 and FX2 knob operations are recorded.
Off, On
7
Restart. On: Always starts playback from the beginning whenever sequence
playback started by pressing the PLAY button. Off: Resumes playback from the
location where playback last stopped.
Off, On
8
Pad Freeze. Specifies whether or not to return pad tone settings to their initial
defaults after all pad tones are changed.
On: Settings are saved, Off: Returns to initial default settings
• When the pad tone type is one that cannot be selected by an all pad tone that
was selected, all of the pad tones are returned to their initial defaults regardless
of this setting. For example, if a pad’s tone was changed to a sound and all pad
tones were changed to melody type, the tones of all of the pads will be returned
to their initial defaults, even if this setting is “On”.
Off, On
5
Menu for configuring sampling settings.
1
Sampling Tempo Sync. On: Sampled sounds are synced with the sequence tempo
when played back. The pitch of the sound also changes in accordance with the
tempo. Off: Sampled sounds are always played back at their tempo when they
were sampled.
This function can be used while all pad tones are drum type, and the pad tones
are samples.
Off, On
2
Auto Sampling. Specifies the timing when sampling starts.
On: Sampling starts upon sound input after the REC button is pressed.
Off: Sampling starts as soon as the REC button is pressed.
• This setting is disabled automatically when the sampling pre-count setting
(below) is enabled (On).
Off, On
3
Sampling Pre-count. On: Sampling starts after a four-beat count. Off, On
4
Sampling Threshold. Sampling starts when the sound being sampled reaches a
preset threshold level. This setting is valid only when the Auto Sampling setting
(above) is enabled (On).
0-127
5
External Only. On: Only external sound sources are recorded. Off, On
External Vol. Internal Vol.
EXT INT
External Vol. Internal Vol.
EXT INT
External Vol. Internal Vol.
EXT INT
MIX FADER position
00
MIX FADER position
01
MIX FADER position
02