User manual

caso MG 20 Menu 67
 Exterior housing
• Clean the exterior surfaces of the device with a damp cloth.
• The stainless steel surfaces can be cleaned with commonly available
stainless steel cleaners.
 Rotating plate, rolling ring and metal rack
• The glass turntable and the metal rack must be removed and cleaned
occasionally. Wash the plate and the rack in a warm soapy solution or in
the dishwasher.
• The rolling ring should be cleaned regularly to prevent excessive noise
development or a rotational malfunctions.
The rolling ring can be washed in a mild soapy solution or in the
dishwasher. Please remember to put the rolling ring back again properly
after cleaning it.
• Wipe the bottom of the oven with a mild cleaning agent. If the floor of the
oven is excessively dirty, you can use a mild cleaning agent.
15 Troubleshooting
This chapter provides you with important notices with regard to operating the
device. Observe the following notices to avoid dangers and damages:
15.1 Safety notices
Attention
► Only qualified electricians, who have been trained by the manufacturer,
may carry out any repairs on electrical equipment.
► Improperly performed repairs can cause considerable dangers for the
user and damages to the device.
15.2 Causes and rectification of faults
The following table assists in localizing and rectifying minor faults.
Error Possible cause Action
The selected program
will not start.
Device door is not closed
Close device door
Power plug is not plugged in
Plug in mains plug!
Fuse is not activated
Activate fuse
The turntable turns
jerkily.
Dirt between the turntable and
the base of cooking camber
Remove dirt
Dirt on rolling ring
Cooking vessel too large Use different cooking vessel