Technical data

Caso Fomini Jet black 26
13.5 Setup location requirements:
 In order to ensure the safe and trouble-free operation of the device, the setup location must fulfil
the following prerequisites:
 The device must be set up on a firm, flat, horizontal surface with sufficient load-bearing
capacity.
 Choose the setup location in such a way that children cannot reach the device.
 The device is not intended to be installed in a wall or a built-in cupboard.
 Do not set up the device in a hot, wet or extremely damp environment or near flammable
material.
 The electrical socket must be easily accessible so that the power lead can be disconnected
easily, in the case of an emergency.
 The installation and assembly of this device in non-stationary setup locations (e.g. on ships)
must be carried out by specialist companies / electricians, provided they guarantee the
prerequisites for the safe use of this device.
13.6 Electrical connection
In order to ensure the safe and trouble-free operation of the device, the following instructions
must be observed for the electrical connection:
 Before connecting the device, compare the connection data (voltage and frequency) on the
rating plate with those of your electrical network. This data must agree in order that no
damages occur in the device
If in doubt, ask your qualified electrician.
 The electrical outlet must be protected by a 16A safety cut-out switch.
 The connection between the device and the electrical network may employ a 3 meter long
(max.) extension cable with a cross-section of 1.5 mm². The use of multiple plugs or gangs is
prohibited because of the danger of fire that is involved with this.
 Make sure that the power cable is undamaged and has not been installed under the device or
over hot or sharp surfaces.
 The electrical safety of the device is only guaranteed if the device is connected to a properly
installed protective conductor system. Operations using an electrical outlet without a protective
conductor are prohibited. If in doubt, have the house installation checked over by a qualified
electrician.
The manufacturer cannot be made responsible for damages that are caused by a missing or
damaged protective conductor.