Specifications

Automatic Routing: PBX and FaxPress Integration Configuring FaxPress
5—59
the Unaddressed mailbox, where they must be viewed and manuallly routed by a
user with Router privileges. Be sure to provide your FaxPress mailbox ID to
people who send you faxes.
Sending faxes via DTMF directly to a FaxPress mailbox requires the sender to use
the following addressing procedure:
1. Using a fax station with a touch tone phone or keypad, dial the FaxPress’
fax number. The FaxPress will answer the call wih a fax data squeal.
2. Wait for the end of the fax data squeal, then press * on the keypad. The
FaxPress will then respond with three tones to confirm DTMF mode. If the
FaxPress does not respond with three tones, try pressing the * again.
3. After the three tones, dial the destination mailbox ID on the touch-tone
keypad, and then press # #. The FaxPress will respond with three tones to
verify input, followed by ready tones.
4. Start the send operation.
If the FaxPress does not have a mailbox with the specified ID, it replies with one
long tone to signify a sequence error. If this happens, clear the error by pressing
# #, then return to step 2.
In short, the DTMF dialing syntax is as follows:
fax number (fax squeal) * (3 tones) mailbox ID ## (3 tones)
For troubleshooting help regarding your DTMF automatic routing, please refer to
the Automatic Fax Routing Troubleshooting link at:
http://www.castelle.com/support/documentation/