Edge Lock Harness Guide

EDGE ESC LOCK HARNESS AND KEY

Mounting

The socket may be

installed through a

panel or secured inside a

fuselage.

Wiring Diagram

Connect the white wire to the Aux Line (white wire) on

an Edge ESC.

Connect the red “+” wire to any servo wire with a Y

harness.

Warning

Edge Arm Lock mode is intended as a

secondary safety device. It is not intended

to replace safe practices or careful handling

of your RC power system, vehicle, and

transmitter.

Edge Arm Lock is only operational if you

have successfully conﬁgured the Edge ESC

using Castle Link software.

Edge Arm Lock requires that the AUX LINE

of the Edge ESC receives a voltage between

1.8V and 8.4V to arm. Failure of the power

source (0 volts) will cause the ESC to enter

Arm Lock mode.

Operation

Key in socket OR disconnected wire in socket harness

= ARM LOCKED.

A properly programmed and wired Edge will be

incapable of arming when the key is in the socket.

If the key is placed in the socket or the arm lock socket

loses power, the ESC will go into a locked state - even

if it is running.

Key removed + power to socket = ARM UNLOCKED. ESC

must receive low throttle signal to arm and run.

PAGE 1
EDGE ESC LOCK HARNESS AND KEY Mounting The socket may be installed through a panel or secured inside a fuselage. Wiring Diagram Connect the white wire to the Aux Line (white wire) on an Edge ESC. Connect the red “+” wire to any servo wire with a Y harness. Operation Key in socket OR disconnected wire in socket harness = ARM LOCKED. Warning A properly programmed and wired Edge will be incapable of arming when the key is in the socket.
PAGE 2
Before completing any of the following steps, make sure that the Edge ESC’s Aux line mode is set to “Arm Lock Key”. This setting can be found on the “OTHER” tab in the Castle Link software. ™ ARM LOCK SOCKET AND KEY ™ © 2013 Castle Creations, Inc.