CC BEC 2.0 WP Instructions

OPEN FLAP FOR WIRING DIAGRAMS

Single battery configuration

1. Solder the CC BEC 2.0 blck ground wire to ESC’s

blck bttery ground wire.

2. Solder the CC BEC 2.0 red power wire to ESC’s red

bttery power wire.

3. If your ESC hs n internl BEC, you must disconnect

the red wire on the ESC’s receiver led.

4. If your ESC does not hve n internl BEC, do OT

disconnect the red wire.

5. Plug both output leds of the CC BEC 2.0 into seprte

chnnels on your receiver.

Voltage Output

Defult setting: 5.25 volts. User selectble in 0.25 volt

increments between 4.75 nd 12 volts.

Cstle Link USB Interfce (P/: 010-0005-00) required to

chnge output voltge (sold seprtely).

Low Input Voltage

In the event tht the input voltge flls below the desired

output voltge, the CC BEC 2.0 output is essentilly equl

to the input level. CC BEC 2.0 cnnot output more voltge

thn the bttery it drws from. The CC BEC 2.0 will not

operte or produce ny output when input voltge drops

below 3.5 volts.

RF Noise

Alwys rnge check your model. This device should be

treted much like  speed control. Try to keep s much

distnce s possible between the rdio receiver nd

components nd the CC BEC unit.

Notes