CSE010-0164-00 Sidewinder SV4 Driver's Ed Guide

confirm that it is fully charged.

5. There will be a sequence of four “rings” and the red LED will blink.

6. Keep holding the trigger, within 6 – 8 seconds there will be a sequence of four “rings” and the yellow LED

will blink. You are now in programming mode; let the trigger return to neutral.

To Make Changes In Programming Mode:

Once in programming mode, the ESC will beep once, pause, then beep once again and repeat until a change

is made with your transmitter. For instance, if you want to adjust setting 1 (Brake/Reverse Type) to option

1 (With Reverse) you would pull full throttle to select it. When the trigger is returned to neutral the beep

pattern will change to 2 beeps followed by 1 beep. By selecting an option, you have now moved on to

setting 2 and option 1. If at setting 2 (Voltage Cutoff) you reject option 1 (Auto-LiPo) by going to full brake/

reverse, the beep pattern will then change to 2 beeps followed by 2 beeps. This means the ESC is still at

setting 2 but is now asking if you would like to accept option 2 (None).