CSE010-0164-00 Sidewinder SV4 Driver's Ed Guide

8
2028 motors only. DO NOT CUT any part of the
wire length from any other motor, regardless of
brand or type. In most cases, only the last 1/4 inch
or so of the motor wires are able to be soldered. If
they are clipped shorter you may not be able to
solder the remaining portion of the wire and the
motor will not run properly, if at all.
If the motor is supplied with connectors you
do not want to use, simply unsolder the original
motor connectors from the wires - do not cut
them off.
Brushed Motor Wiring, Reversing
(Figure 2)
Use this mode if you wish to use reverse. Make
Figure 2