CSE010-0164-00 Sidewinder SV4 Driver's Ed Guide

20
At each option, you can accept it by going to full throttle on your transmitter, or you can reject the option
by going to full brake. In programming terms, full throttle is ‘YES’ and full brake is ‘NO.’ The ESC will indicate
that it has accepted your selection by producing a continuous “skipping” tone. When you hear this tone,
allow the trigger to go back to the neutral position to advance to the next setting or option depending on
your selection.
How To Get Into Programming Mode:
1. Turn your transmitter on.
2. Plug the battery into the ESC with its switch off. If your ESC does not have a switch, hold full throttle on
your transmitter before plugging in the battery.
3. Hold full throttle on your transmitter and turn the ESC switch on.
4. The ESC will go through its boot-up sequence and blink the green LED. If the ESC’s voltage cutoff is set
to Auto-LiPo (the default setting), then the ESC will emit a sequence of beeps indicating the number of
battery cells. If the number of beeps does NOT match the number of cells, disconnect the battery and